Why Won’t My Mercedes Benz Diesel Start? – Part 2 by Kent Bergsma

www.mercedessource.com – Diagnosing NO START engine problems on older Mercedes Benz. Part 2 of a two part video series. For 190D 200D 220D 240D 300D 300CD 300TD 300SD 300SDL 350SD

Tags: Benz, Bergsma, Diesel, Kent, Mercedes, Part, start, wont

8 Responses to “Why Won’t My Mercedes Benz Diesel Start? – Part 2 by Kent Bergsma”

1. FrenchValleyAirport says:

   January 5, 2012 at 1:28 pm

   can you use injector cleaner? my? master tech teacher told me injector cleaners work great for cars and acctualy work. .
2. IraHayesIraHayes says:

   January 5, 2012 at 1:28 pm

   My car clicks sometimes instead of starts. . . and after it does start, there’s a loud noise like the starter is still turning for a few seconds until? I rev it up. . . What the bleep is wrong? HELP ME! =) Thanks
3. michaelpack1988 says:

   January 5, 2012 at 2:05 pm

   My Mercedes had no problem starting, but what it would so is if I drive over 40mph, It would? loose power. You can put it to the floor and nothing. Let it idle for a second, then it would be fine, until you went over 40. I was rather slow so what I did is clean out the Alda banjo bolt it was stopped up completely, did a diesel purge, replace the primary and secondary filters, and no it can cruise at 90+. Lubro moly diesel purge it some great stuff, all kinds of trash came out of my pump.
4. imomost says:

   January 5, 2012 at 2:57 pm

   What should I do if i loosen up the injector line and get no fuel coming out during startup(not a drop). ? Just went to your site and bought the 2 filters that are under the hood since it seemed like the most logical place to start. I’ll get the tank filter
   later.
   Thanks
   Omar
5. imomost says:

   January 5, 2012 at 3:54 pm

   What should I do if i loosen up the injector line and get no fuel coming out during startup(not a drop). Just went to your site and bought the 2 filters that are under the hood since it seemed like? the most logical place to start. I’ll get the tank filter later.
   Thanks
   Omar
6. nhojcam says:

   January 5, 2012 at 4:19 pm

   good video! thanks kent!? folks, this guy knows his stuff! he was a former aircraft mech and knows these older mercedes very well. just put a . com behind his username here on youtube and you can visit his site.
7. Mercedessource says:

   January 5, 2012 at 4:58 pm

   @sgtpepper1138
   Opps must have been a slurrrr. . . I meant to say ” Ream out the carbon in the glow plug holes. “? Check out my other video on use of this special reamer.
8. sgtpepper1138 says:

   January 5, 2012 at 5:22 pm

   What do? you mean “remount the carbon in the glowplug holes?”